ZY series vibrating screen installation and commissioning: Hydrolyzed Sponge White Powder Sponge Chengdu Sino Tech company , https://www.cnherbfun.cn
(1) Equipment should have a stable foundation. When the equipment is installed on a general ground or cement foundation, the anchor bolts may not be provided. When the equipment is installed on the steel structure frame, the bolts are fastened to the steel structure, and the steel structure frame should have a certain degree of steel.
This machine only needs one three-phase switch (remark: zui is good to use the electric control panel), thread the snake skin, connect the motor to the power supply, and pay attention to the electrical control panel should be suspended and mounted on the wall.
(2) The screen has been installed before leaving the factory, and the screen replacement during use can be replaced by itself.
(3) Before starting the machine, first check the tightening degree of each compression bolt, and whether the position of each material port is aligned with the feeder, and observe whether the vibration motor can rotate normally and whether the spring force is blocked or not. Whether the layer screen is compacted.
(4) Before the vibration vibrating screen is connected to the electric control panel, the electrical control panel should be inspected first. After the line is connected, observe whether the direction of rotation of the vibration motor is clockwise. (Note: Otherwise, the phase sequence should be changed) Whether the operation is normal or not.
(5) Adjust the phase angle of the upper and lower eccentric blocks of the vibration motor to adapt to the screening of various materials.
Rotary vibrating screen installation and commissioning