Agricultural machinery maintenance emergency tips

Cracks in metal tubing or trachoma can be broken at the break, find a suitable diameter, a certain degree of tightness of the plastic tube (preferably new) sleeve up, both ends with a thin wire can be tight; can also be temporarily coated with soap or Attach tape to the leak.

The rupture of the oil pump diaphragm can be done by layer-by-layer patching or by cutting the tarpaulin, plastic film, etc. into the diaphragm. If the clearance between the rocker arm and the outer rocker arm in the oil pump is too large, the iron skin, iron wire or split pin can be stuffed in the gap and tied tightly with fine iron wire.

If the fan blade breaks only one piece, one piece of the opposite piece can be removed to maintain the smooth operation of the fan. If the fan blade is severely damaged, it can be replaced with a home fan blade, which is mounted on the fan bracket.

If the water on the cylinder head leaks due to the looseness of the water, use a flat iron rod to press up the protruding part of the water, and then use a hammer to tap it to make it tight. If it is caused by rust perforation, glue, thick cloth can be used. Paste layer by layer.

Copper gaskets hardened oil leaks can put copper gaskets in the fire to burn red, and then quickly cool, so that the copper sheet becomes soft and reinstall.

The starter gear and the flywheel ring gear bite and loosen the fixed bolts of the starter, put the shift lever in the neutral position, and crank the crankshaft with the starter handle to release the meshed gear.

Single-cell damage of the battery can be broken by a metal wire such as a thin wire to remove the damaged one.

The tie rod ball pin breaks off and the broken pin is removed, and a bolt with the same length as the ball stud pin is mounted instead. If the hexagonal head of the bolt is not high enough, add a washer. After installing the knuckle arm and nut, rivet the exposed part of the bolt.

The leaf springs can be broken by placing large wooden blocks between the leaf springs, the axle and the frame, and tied with wires or ropes to drive slowly at low speeds.

We provide whole set custom-made grain/bean cleaning plant solution. According to raw material condition/ cleaning requirement/budget, our experienced engineer will design appropriate Grain Cleaning Plant for customer.

We built grain cleaning plants over the 5 continents. Cleaning material includes quinoa, sesame, wheat, maize, paddy, chickpea, red kidney beans, etc. From small chia seeds to big pulses, we can offer you the cleaning solutions. Capacity ranges from 3 ton per hour to 10 ton per hour. Our engineer make reasonable plant layout in your workshop. No matter one-floor plant design consisting 3 or 4 machines or two-floor plant design including machines more than 10 sets. On-site plant installation and plant operation training are available. You do not need worry about plant running and after-sales service.

One set grain cleaning plant normally including the flowing single seed cleaning equipment: seed cleaner & grader, Gravity Separator , destoner, Indented Cylinder , color sorter, elevator, conveyor, Bagging Scale . Besides this, the outdoor dust cleaning system, power control panel, underground hopper is also the main features of the grain bean cleaning plant. Combining of different cleaning purpose machines, the Grain Seed Cleaning Plant can reach cleaning rate of 98%.

10 tons per hour barley plant in Australia

It is one simple 10 tons barley cleaning plant we built in Australia. The main machines have barley deawner, Fine Seed Cleaner , gravity separator, bagging scale system.

Main machine functions introduction:

Barley deawner: remove the husk/ shell coated on barley seeds.

Fine seed cleaner: remove the dust, light impurity as husk, straw, big impurity and small impurity.

Gravity separator: remove the immature, eaten, sicken, shrink seeds.

Bagging Scale System: weighing and packing seeds to bags.

8 tons/hour kidney bean and 6 tons/hour Sesame Seed Cleaning Plant in Ethiopia

Following is one two-floor Seed Cleaning Plant reference. This grain cleaning plant is used to clean sesame, chickpea, soybean, red kidney beans. One seed cleaning plants can be used to clean different kinds of seeds.  Only needing is to change suitable sieves/ sieve bed for different seeds. This plant cleaning kidney beans capacity is 8 tons per hour, and 6 tons per hour when clean sesame.

Grain And Bean Cleaning Plant

Grain And Bean Cleaning Plants,Sesame Seed Cleaning Plant,Bean Cleaning Plants,Grain Bean Seed Cleaning Plants

SHIJIAZHUANG SYNMEC INTERNATIONAL TRADING LIMITED , https://www.seedgraincleaner.com